Available on

Lever Operated Chain Hoist: Hoist Inspection Methods and Criteria Mobile App

The Lever Operated Chain Hoist: Hoist Inspection Methods and Criteria mobile app provides important information for personnel involved with the installation, operation and maintenance of this product. Although you may be familiar with this or similar equipment, it is strongly recommended that you read this manual before installing, operating or maintaining the product. Hoists that are used infrequently shall be inspected as listed in the app or as determined by a qualified person. Frequent Inspections are not intended to involve disassembly of the hoist. Disassembly for further inspection would be required only if frequent inspection results so indicate. Disassembly and further inspection should only be performed by a qualified person trained in the disassembly and re-assembly of the hoist. Periodic Inspections require disassembly of the hoist is required. Disassembly should only be performed by a qualified person trained in the disassembly and re-assembly of the hoist.

Construction, Repair & Improvement mobile forms and apps for your team

Convert your inefficient paper Checklists and other forms to mobile versions with GoCanvas.

Want to learn more about GoCanvas?

Request a Demo

Take a Tour

Take a peek inside the Lever Operated Chain Hoist: Hoist Inspection Methods and Criteria Mobile App

Included Features

Our App Builder gives you the power to easily add and remove the ones you want. {{controller.show_all ? 'See included features.' : 'See more features.'}}

{{data.title}}

Included Fields

Customize to add, remove, or edit any of the fields below.

Date
Company
Jobsite
Lever Location
Inspector
Signature
Visual, Auditory Check
Mechanisms should be properly adjusted and should not produce unusual sounds when operated.
Repair or replace as required.
Visual Check
Brake Pawl, Pawl Shaft and Pawl Spring should not be deformed, scarred or show significant wear.
Replace
Visual Check, Measure
The surface of the friction plate should be free of grease, oil, scars, gouges and wear and have ...
The outer thickness should not be thinner than the inner thickness.
Replace
Visual Check
The surface of the friction plate should be free of scars, gouges and wear.
Replace
Measure
The bushing should have uniform thickness.
Replace
Visual Check
When slightly heated, the bushing should be so lubricated that lubricant oozes off the surface.
Soak bushing in machine oil for one day.
Measure
The “D” dimension should not be less than the discard value.
Replace
...and More!