Available on

Belt Conveyor: Maintenance Schedules Mobile App

To ensure belt conveyor is safely and correctly utilized, all instructions within the Belt Conveyor: Maintenance Schedules mobile app and the manual must be read and understood prior to equipment start-up. Be aware of all safety labels on machinery. If you do not understand any of the safety instructions or feel there may be safety labels missing, contact your supervisor or product supplier immediately! The app includes a detailed Maintenance Schedules checklist. Compliance with safety standards, including federal, state and local codes or regulations is the responsibility of the conveyor purchaser(s). Anyone you email a document to on a MyCanvas-enabled app will get a MyCanvas account set up for them that is associated with their email address.

Want to learn more about GoCanvas?

Request a Demo

Take a Tour

Take a peek inside the Belt Conveyor: Maintenance Schedules Mobile App

Included Features

Our App Builder gives you the power to easily add and remove the ones you want. {{controller.show_all ? 'See included features.' : 'See more features.'}}

{{data.title}}

Included Fields

Customize to add, remove, or edit any of the fields below.

Note: If equipment repair or replacement is required during inspections, thoroughly review the ma...
Inspect all conveyors to ensure that all guarding is securely in place.
Inspect belt tracking for at least (3) full belt revolutions.
Inspect conveyor for loose bolts and set screws.
Inspect bearings, gear reducers, motors and chains for excessive noise or heat.
Inspect belt to ensure that there is not excessive wear and that all splices are intact.
Inspect belt tension.
A) Prevent slippage between drive pulley (sheaves for spurs) and belt under a full load.
B) Force belt to conform to the crown on crowned pulleys.
Inspect rollers to ensure that they rotate freely without excessive noise.
Inspect oil level in reducer.
Inspect reducer for leaking seals.
Inspect conveyor for loose bolts.
Inspect drive chains, jump chains and sprockets for wear, alignment and proper chain tension.
Check guide system wheels to ensure all bearings are intact and wheel covers are not worn through...
Lubricate pulley shaft bearings.
Grease all pulley shaft bearings.
Inspect conveyors for worn or broken drive belts.
Tighten all bearing set screws if not completely tight.
Change oil in reducers.
...and More!